DESCRIPTION
JIAYUAN 600 Hi-Temperature Red Gasket Maker is a one-part,moisture curing, RTV (room temperature vulcanizing) silicone that cures to form a tough rubber gasket. ASI 600 was specifically formulated to be used as a formed-in-place gasket where operating temperatures up to 310°C (600°F) are reached intermittently. JIAYUAN 600 will remain permanently flexible and provides excellent resistance to aging, vibration and shock.

TYPICAL USES
The primary use for JIAYUAN 600 is
formed-in-place gaskets in high
temperature applications to replace
conventional paper and cork
gaskets. Such uses include:
Automotive
valve covers
axle housings
water and oil pump seals
thermostat housings
bearing cap seals
timing chain covers
fuel pumps to blocks
solenoid covers

INDUSTRIAL:
pump and compressor gaskets
appliance door gaskets
humidifier gaskets
air conditioner gaskets
repairing torn silicone rubber
sheets
ductwork gaskets
dust collection components
wire and cable insulation
furnace door gaskets

DIRECTIONS
JIAYUAN 600 is ready to use and
requires no mixing or additives. The
cure mechanism begins as soon as
the sealant comes in contact with
the air. At conditions of 25°C (77°F)
and 50% relative humidity, the
sealant will skin in 10 minutes and
cure within 24 hours (1/4 bead),
ultimate cure in 7 days.

SURFACE PREPARATION:
All surfaces should be clean and
dry. It is recommended that bonding
surfaces be solvent wiped with a
naphtha, ketone or chlorinated
solvent. Suitable solvents include
xylol, toluol and mineral spirits.
Do not solvent wipe with alcohols or
oil-containing solvents such as
Varsol.
For gasket applications, apply an
even bead, with a diameter of 1/8 or
less, to one surface, making certain
to surround all bolt holes. Press, do
not slide parts together, and torque
normally. On surfaces where
adhesion is not desired, a light coat
of oil or grease will act as a release
agent.
If removal of JIAYUAN  600 is necessary,
it can be wiped off surfaces to be
mated when uncured. After the
material cures, it can be abraded or
scraped from the surface.
JIAYUAN 600 is not recommended as a
gasket for cylinder heads, manifolds
or in contact with fuels.