Detailed Product Description

PRODUCT DESCRIPTION
S-BOND Gasket Maker is a single component,
room temperature, vulcanizing,  gasketing compound designed
to provide reliable formed-in-place gaskets for mechanical
assemblies.  This material cures on exposure to moisture in the
air to form a tough, flexible, silicone rubber gasket.  The product
resists aging, weathering and thermal cycling without hardening,
shrinking or cracking.  Designed to provide increased oil
resistance and complies to extended warranty requirements.
PRODUCT BENEFITS
·  Improved oil resistance
·  Sensor safe, non-corrosive
·  Good adhesion and flexibility
·  Replaces most cut gaskets
·  Can be used as a gasket maker or dressing
·  Non-flammable, Non-toxic
·  Low odor
 
  TYPICAL APPLICATIONS
·  Oil pans
·  Transmission pans
·  Valve covers
·  Valves and guides
·  Timing gear covers
·  Differential covers

DIRECTIONS FOR USE
For assembly as a form-in-place gasket
1. Remove all previous material from mating surfaces.

 S-BOND GREY Gasket Remover is recommended for
most materials, not for plastics or painted surfaces.
2. For best results, clean and dry all surfaces with a
residue-free solvent..
3. Cut nozzle to desired bead size, 1/16 to 1/4 in
diameter. An 1/8 bead is usually sufficient for most
applications.
4. Remove cap, puncture tube or cartridge seal and attach
extension nozzle.
5. Apply a continuous and even bead of silicone to one
surface, first tracing the internal areas of the gasket
configuration, then all surrounding bolt holes.
6. Assemble parts immediately while silicone is still wet.
Secure or tighten to recommended torque specs.
7. Re-torque will not be necessary after the product has
cured.

For assembly as a gasket dressing
1. Repeat steps 1 through 4 as in previous section.
2. Apply a thin film of silicone to one surface to be sealed.
3. Place the pre-cut gasket onto silicone film.
4. Apply a second thin film to pre-cut gasket surface.
5. Remove any excess and assemble parts immediately.
Note: Product is not recommended for use as a cylinder
head gasket or head gasket sealant.

For Cleanup
1. Allow excess material to extend beyond the extension
nozzle or aerosol tip to cure, sealing and protecting the
remaining product from moisture.  For reuse, simply
remove the cured product from the tip.
2. Remove uncured product from parts and hand-tools with
a dry cloth.  If skinned over, break film with a dry cloth to
remove as much as possible. 
3. Clean hands with a dry cloth or hand cleaner.

GENERAL INFORMATION
This product is not recommended for use in pure oxygen
and/or oxygen rich systems and should not be selected as
a sealant for chlorine or other strong oxidizing materials.